DTC P0766:00: Notes
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION CHART
| DTC P0766:00 |
Shift solenoid D stuck off |
| DETECTION CONDITION |
- The TCM detects that revolution ratio of the input revolution to output revolution is 2.185 or less for 1 s four times when the following conditions are met.
- M position
- 1GR
- Accelerator pedal position: 4.67% or more
- The TCM detects that revolution ratio of the input revolution to output revolution is 1.277 or more or 0.57 or less when the following conditions are met.
- 4GR
- Vehicle speed: 30 km/h {19 mph} or more
Diagnostic support note
- The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
- The AT warning light illuminates.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Shift solenoid D malfunction
- Line pressure malfunction
- Primary control valve body malfunction
- TCM malfunction
|