DTC P0762:00: Notes
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION CHART
| DTC P0762:00 |
Shift solenoid C stuck on |
| DETECTION CONDITION |
- The TCM detects that revolution ratio of the input revolution to output revolution is between 1.404-1.704 when the following conditions are met.
- 3GR
- Vehicle speed: 36 km/h {22 mph} or more
- TCC operation: Off
Diagnostic support note
- The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
- The AT warning light illuminates.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Shift solenoid C malfunction
- Line pressure malfunction
- Primary control valve body malfunction
- TCM malfunction
|