DTC P0761:00: Notes
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION CHART
| DTC P0761:00 |
Shift solenoid C stuck off |
| DETECTION CONDITION |
- The TCM detects that revolution ratio of the input revolution to output revolution is 2.185 or less for 1 s four times when the following conditions are met.
- 1GR
- Accelerator pedal position: 4.67% or more
- The TCM detects that revolution ratio of the input revolution to output revolution is 2.185 or more or 1.277 or less for 1 s three times when the following condition is met.
Diagnostic support note
- The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
- The AT warning light illuminates.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Shift solenoid C malfunction
- Line pressure malfunction
- Primary control valve body malfunction
- TCM malfunction
|