DTC P0733:00: Notes
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION CHART
| DTC P0733:00 |
Gear 3 incorrect ratio |
| DETECTION CONDITION |
- The TCM detects that revolution ratio of the input revolution to output revolution is 2.185 or more for 5 s when the following condition is met.
- The TCM detects that revolution ratio of the input revolution to output revolution is between 1.404-1.704 for 2 s when the following conditions are met.
- 3GR
- Vehicle speed: 36 km/h {22 mph} or more
- TCC operation: Off
- The TCM detects that revolution ratio of the input revolution to output revolution is 0.863 or less for 5 s when the following conditions are met.
- 3GR
- Vehicle speed: 42.5 km/h {26.4 mph} or more (changes by accelerator pedal position)
- TCC operation: Off
Diagnostic support note
- The MIL does not illuminate.
- The AT warning light illuminates.
- PENDING CODE is not available.
- FREEZE FRAME DATA is not available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Solenoid valve malfunction
- Pressure control solenoid A
- Shift solenoid A
- Shift solenoid C
- Line pressure malfunction
- Stall speed malfunction
- Forward clutch slipping
- 3-4 clutch slipping
- Primary control valve body malfunction
- TCM malfunction
|