DTC P0731:00: Notes
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION CHART
| DTC P0731:00 |
Gear 1 incorrect ratio |
| DETECTION CONDITION |
- The TCM detects that revolution ratio of the input revolution to output revolution is 2.185 or less for 1 s four times when the following conditions are met.
- 1GR
- Accelerator pedal position: 4.67% or more
Diagnostic support note
- The MIL does not illuminate.
- The AT warning light illuminates.
- PENDING CODE is not available.
- FREEZE FRAME DATA is not available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Solenoid valve malfunction
- Pressure control solenoid A
- Shift solenoid A
- Line pressure malfunction
- Stall speed malfunction
- Forward clutch slipping
- One-way clutch No. 1 slipping
- Primary control valve body malfunction
- TCM malfunction
|