LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Manual Transaxle Clutch [G66M-R]) >> Clutch Pedal Removal/Installation >> Starter Interlock Switch Installation Note

Starter Interlock Switch Installation Note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • The starter interlock switch may not operate normally if the rod is pushed in. Do not push in the rod when installing the starter interlock switch.
  1. Insert a new starter interlock switch into the pedal bracket hole in the direction of arrow A.
  2. While pressing the starter interlock switch in the direction of arrow A, slide it until it locks in the direction of arrow B to secure it.
  3. Fully depress the clutch pedal in the direction of arrow C, and verify that a click sound from the starter interlock switch is heard.
Fig 1: Clutch Pedal, Pedal Bracket And Starter Interlock Switch
G06205785Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals