LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Charging System [MZR 2.5]) >> Generator Inspection [MZR 2.5] >> Generator >> PCM and generator shearing inspection

PCM and generator shearing inspection

WARNING: This page is about a different variant/trim than selected.
  1. Connect the M-MDS to the DLC-2.
    Fig 1: DLC-2
    G06205129Courtesy of MAZDA MOTORS CORP.
  2. Inspect as follows:
PCM AND GENERATOR SHEARING INSPECTION CHART

Step Inspection Action
1 Measure the generator terminal B voltage when the electrical loads(1) are on and off. 15 V or more Go to Step 2.
13-15 V Normal(2)
13 V or less Go to Step 3.
2 Monitor the ALTT V PID using the M-MDS, (See ON-BOARD DIAGNOSTIC TEST [MZR 2.5] .) or measure the PCM 2AF terminal waveform using an oscilloscope. (See PCM INSPECTION [MZR 2.5] .)
Is the value normal?		 Yes Go to Step 4.
No Inspect the following, then repair or replace as necessary.
  • If there is no malfunction, replace the PCM.

  1. Wiring harness between PCM terminal 2AF-generator terminal P.
  2. Wiring harness between PCM terminal 2AA-generator terminal D.
  3. Generator inner parts.
3 Monitor the ALTT V PID using the M-MDS, (See ON-BOARD DIAGNOSTIC TEST [MZR 2.5] .) or measure the PCM 2AF terminal waveform using an oscilloscope. (See PCM INSPECTION [MZR 2.5] .)
Is the value normal?		 Yes Go to Step 5.
No Inspect the following, then repair or replace as necessary.
  • If there is no malfunction, replace the PCM.

  1. Wiring harness between PCM terminal 2AF-generator terminal P.
  2. Wiring harness between PCM terminal 2AA-generator terminal D.
  3. Generator inner parts.
4 Monitor the ALTF PID using the M-MDS, or calculate the duty value of the PCM terminal 2AA using an oscilloscope. Is the duty value 100%?
G07620633
 Yes Replace PCM.
No Inspect the following, then repair or replace as necessary.
  • If there is no malfunction, replace the PCM.

  1. Wiring harness between PCM terminal 2AA-generator terminal D.
  2. Generator inner parts.
5 Monitor the ALTF PID using the M-MDS, or calculate the duty value of the PCM terminal 2AA using an oscilloscope. Is the duty value 0%?
G07620634
 Yes Replace PCM.
No Inspect the following, then repair or replace as necessary.
  • If there is no malfunction, replace the PCM.

  1. Wiring harness between PCM terminal 2AA-generator terminal D.
  2. Generator inner parts.
(1) Headlights, blower motor, rear window defroster, brake lights, etc.
(2) If the generator field coil duty value does not change when electrical loads (such as headlights, blower motor, rear window defroster, brake lights) are on or off, inspection with discharged battery is needed.
scientia non olet · About LEMON Manuals