Pin point test
WARNING: This page is about a different variant/trim than selected.
- Verify the battery condition using the Battery Analyzer.
- If the meter read, GOOD BATTERY, inspect the generator. (See GENERATOR INSPECTION [MZR 2.5] .)
- If the meter read, GOOD-RECHARGE, charge the battery and inspect the generator. (See GENERATOR INSPECTION [MZR 2.5] .)
- If the meter read, CHARGE&RETEST, fully charge the battery and retest.
- If the meter read, REPLACE BATTERY, install a new battery.
- If the meter read, BAD CELL-REPLACE, install a new battery.