Plug Gap Inspection
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- To avoid possible damage to the tip, do not adjust the plug gap.
- To prevent damaging the tip, use a wire type plug gap gauge when inspecting the plug gap.
- Measure the spark plug gap using a wire type plug gap gauge.
- If not within the standard specification, replace the spark plug.
Spark plug gap
Standard: 1.25-1.45 mm {0.049-0.057 in}
New spark plug (reference): 1.25-1.35 mm {0.049-0.053 in}