On-Board System Readiness Tests Access Procedure

WARNING: This page is about a different variant/trim than selected.

Connect the M-MDS (IDS) to the DLC-2.
After the vehicle is identified, select the following items from the initialization screen of the IDS.
1. Select "Powertrain".
2. Select "OBD Test Modes".
3. Select "Mode 1 Powertrain Data".
4. Select "PCM".
Then, select the "***SUP" and "**EVAL" PIDs in the PID selection screen.
Monitor those PIDs and check it system monitor is completed.

Fig 1: DLC-2

Courtesy of MAZDA MOTORS CORP.

NOTE:

If the on-board system readiness tests are not completed the PCM stores DTC P1000.