LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (On-Board Diagnostic [Engine Control System MZR 2.5]) >> DTC P061F:00 >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 VERIFY RELATED PENDING AND STORED DTC 
  • Switch the ignition to off, then to ON (engine off).
  • Verify pending and stored DTCs using the M-MDS.

    (See ON-BOARD DIAGNOSTIC TEST .)

  • Are any other DTCs present?
 Yes Go to the applicable DTC inspection. (See DTC TABLE .)
No Go to the next step.
3 INSPECT PCM CONNECTOR CONDITION 
  • Switch the ignition to off.
  • Disconnect the PCM connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the terminal and/or connector, then go to the next step.
No Connect the PCM connector and verify that the connector seat correctly, then go to the next step.
4 VERIFY DTC TROUBLESHOOTING COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the M-MDS.

    (See AFTER REPAIR PROCEDURE .)

  • Perform the KOEO or KOER self test. (See KOEO/KOER SELF TEST .)
  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection. (See DTC TABLE .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals