DTC Table [Immobilizer System (Keyless Entry System)]

NOTE:

The security light flashes or illuminates under the following conditions when the ignition is switched to off or ACC position.
- There is a malfunction:
  - DTC 16 or below: Flashes for approx. 1 min and the DTC flash pattern indicated in the table below repeats 10 times.
  - DTC 21 or higher: Illuminates for approx. 1 min and the DTC flash pattern indicated in the table below repeats 10 times.
  - If more than one DTC is detected, only the DTC with the lowest number is displayed.
- There is no malfunction
  - The security light illuminates for approx. 3 s and then turns off.

DTC CHART (IMMOBILIZER SYSTEM - KEYLESS ENTRY SYSTEM)

DTC

Detection condition

Page

Security light flashing pattern

M-MDS display⁽¹⁾

Instrument cluster

PCM

B10D9:87

P1260:00

No detected communication with coil antenna

(See SECURITY LIGHT: 11, DTC: B10D9:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

B10D5:13

P1260:00

Coil antenna malfunction
PCM or instrument cluster determined a malfunction in coil antenna even though it is normal

(See SECURITY LIGHT: 12, DTC: B10D5:13/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

B10D7:05

P1260:00

Key ID number program error

(See SECURITY LIGHT: 13, DTC: B10D7:05/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

B10D7:94

P1260:00

Key ID number data cannot be read

(See SECURITY LIGHT: 13, DTC: B10D7:94/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

B10D7:81

P1260:00

Instrument cluster cannot read key ED number data normally

(See SECURITY LIGHT: 14, DTC: B10D7:81/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

B10D7:51

P1260:00

Instrument duster has detected unprogrammed key ID number

(See SECURITY LIGHT: 15, DTC: B10D7:51/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

U0100:87

P1260:00

Communication error between instrument duster and PCM f no response)

(See SECURITY LIGHT: 16, DTC: U0100:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

B10D8:00

P1260:00

Only one key or no key has been programmed

(See SECURITY LIGHT: 21, DTC: B10D8:00/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

B10DA:51

P1260:00

Communication error between instrument duster and PCM (data transfer failure)

(See SECURITY LIGHT: 22, DTC: B10DA:51/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

B10DA:62

P1260:00

ID number data in instrument cluster and PCM do not match

(See SECURITY LIGHT: 23, DTC: B10DA:62/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)

Not illuminated

U0001:88

U0073:00

Instrument cluster communication error (HS-CAN)

U0100:00

Communication error with PCM

⁽¹⁾	The letters at the beginning of each DTC are only displayed when using the M-MDS, and refer to the following: B= Body system, P= Powertrain system, U= Network communication system.