Fuel Tank Pressure Sensor Removal / Installation

With the vehicle in NEUTRAL, position it on a hoist. See Lifting .
Disconnect the electrical connector.

Fig 1: Locating Electrical Connector
Courtesy of MAZDA MOTORS CORP.
NOTE:
- A new vapor line assembly must be installed for a new pressure sensor to be installed.
Remove the fuel tank pressure sensor and fuel line assembly.
To install, reverse the removal procedure.

Perform Leak Test. See EVAPORATIVE EMISSION SYSTEM LEAK TEST , .
Perform the Evaporative Emission Running Loss Monitor Repair Verification Drive Cycle Test. See Drive Cycles , .