Canister Purge Valve Removal / Installation

Fig 1: Identifying Canister Purge Valve Components

Courtesy of MAZDA MOTORS CORP.

WARNING:

• The evaporative emission (EVAP) system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents the danger of explosion or fire. Disconnect the negative battery cable from the battery to minimize the possibility of an electrical spark occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel is present in the area. Failure to follow these instructions may result in personal injury.

1. Disconnect the battery. See Battery Disconnect .
   Fig 2: Locating Evaporative Emission (EVAP) Vapor Management Valve Bracket

   Courtesy of MAZDA MOTORS CORP.
2. Slide the evaporative emission (EVAP) vapor management valve off the bracket.
   Fig 3: Locating Quick Connect Coupling And EVAP Vapor Management Valve Electrical Connector

   Courtesy of MAZDA MOTORS CORP.
3. Disconnect the intake manifold vapor tube-to-EVAP vapor management valve quick connect coupling, fuel tank vapor tube-to-EVAP vapor management valve quick connect coupling and the EVAP vapor management valve electrical connector.
4. Remove the valve.
5. To install, reverse the removal procedure.

• Perform Leak Test. See EVAPORATIVE EMISSION SYSTEM LEAK TEST , .
• Perform the Evaporative Emission Running Loss Monitor Repair Verification Drive Cycle Test. See Drive Cycles , .