Engine Air Cleaner Removal / Installation - 4.0L

WARNING: This page is about a different car, the 2009 Mazda B4000. However, it is still accessible from the selected car via links, so may be relevant.

Loosen the clamp and disconnect the engine air cleaner (ACL) outlet pipe from the air cleaner outlet
Tightening torque:

3 Nm {0.3 kgf-m, 27 in-lbf}
Disconnect the mass air flow (MAF) sensor electrical connector.
NOTE:
- Pry the ACL from the base.
Remove the ACL assembly.

Fig 1: Prying ACL Assembly From Base
Courtesy of MAZDA MOTORS CORP.
NOTE:
- Clean the engine air cleaner with a dry, clean cloth.
To install, reverse the removal procedure.