LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> B2300 Standard >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Mechanical [Lubrication System 2.3L] >> Oil Pressure Sensor Removal / Installation - 2.3L

Oil Pressure Sensor Removal / Installation - 2.3L

  1. With the vehicle in NEUTRAL, position it on a hoist. See Lifting
  2. Disconnect the battery ground cable. See Battery Disconnect .
  3. Disconnect the wire connector at the sender.
    4. Fig 1: Locating Oil Pressure Sensor
    G04307759Courtesy of MAZDA MOTORS CORP.
  4. Remove the oil pressure sender.
  5. To install, reverse the removal procedure.
    Fig 2: View Of Oil Pressure Sensor With Torque Specifications
    G04307760Courtesy of MAZDA MOTORS CORP.
    • Apply sealant to oil pressure sender threads.
scientia non olet · About LEMON Manuals