LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> B2300 Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Symptom Troubleshooting (Engine) - (4 Of 4) >> Connector ENDVIEWS - General Tests >> General Pinpoint Test 10: Fuel Line Pressure/Fuel Pressure Hold Inspection

General Pinpoint Test 10: Fuel Line Pressure/Fuel Pressure Hold Inspection

GENERAL PINPOINT TEST FUEL LINE PRESSURE/FUEL PRESSURE HOLD INSPECTION

PINPOINT TEST 10 FUEL LINE PRESSURE / FUEL PRESSURE HOLD INSPECTION
STEP INSPECTION ACTION
1 CHECK FUEL PRESSURE
WARNING:
  • Before performing the following operation, release the fuel pressure from the fuel system to reduce the possibility of injury or fire. See FUEL PRESSURE RELIEF .

  • Install fuel pressure gauge SST 49 UN01 010.
  • Key ON, Engine OFF (KOEO).
  • Connect IDS or equivalent tester to the DLC and select Active Command Mode.
  • Select OUTPUT TEST MODE.
  • Press MODE to change to the "ALL ON" mode, and press start to run fuel pump.
  • Turn relay off.
  • Observe fuel pressure.
  • Is fuel pressure between 207-448 kPa (30-65 psi)? 
 Yes Go to next step.
No Zero or low pressure:
Check fuel pump.
If as specified, check fuel line and/or fuel filter for clog or restriction.
Pressure high:
Go to next step.
2 CHECK FUEL PRESSURE AFTER ONE MINUTE
  • Observe fuel pressure after 1 minute.
  • Is fuel pressure within 34 kPa (5 psi) of previous reading? 
 Yes Fuel pressure hold inspection OK.
No Check the following:
scientia non olet · About LEMON Manuals