Canister Purge Solenoid: Service and Repair

PURGE SOLENOID VALVE REMOVAL/INSTALLATION [L3]

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the plug hole plate. Service and Repair

4. Remove the purge solenoid valve following procedure:

CAUTION:
- Do not disconnect the purge solenoid valve and evaporative hose except when replacing the purge solenoid valve because it may cause evaporative gas leakage.

a. Disconnect the purge solenoid valve connector.

b. Disconnect the evaporative hose at the charcoal canister side.

c. Remove the bracket shown in the figure.






d. Disconnect the evaporative hose at the intake manifold side.

e. Disconnect the quick release connector (Type A). Service and Repair

5. Install in the reverse order of removal.

Evaporative Hose Installation Note

1. Install the evaporative hose and clamp as shown in the figure.