Solenoid Valve Removal/Installation [FN4A-EL]

SOLENOID VALVE REMOVAL/INSTALLATION [FN4A-EL]

1. Remove the battery duct and battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the under cover.

4. Remove the control valve body. Control Valve Body Removal [FN4A-EL]

5. Remove the solenoid valve (s).






6. Apply ATF to a new O-ring and install it on the solenoid valve.

7. Install the solenoid valve in the control valve body.






Tightening torque
- 7.8-10.8 Nm
{80-110 kgf-cm, 69.5-95.4 in-lbf}

8. Install the control valve body. Control Valve Body Removal [FN4A-EL]

9. Install the under cover.

10. Connect the negative battery cable.

11. Install the battery duct and battery cover. Removal and Replacement

12. Add ATF and, with the engine idling, inspect the ATF level and inspect for leakage. Automatic Transaxle Fluid (ATF) Inspection [FN4A-EL]

13. Perform the mechanical system test. FN4A-EL Transmission