Parking Brake Lever: Testing and Inspection

PARKING BRAKE LEVER INSPECTION

Stroke Inspection

1. Pump the brake pedal a few times.

2. Pull the parking brake lever two to three times.

3. Inspect the parking brake stroke by slowly pulling at point A 50 mm {1.97 in} from the end of the parking brake lever with a force of 98 N {10 kgf, 22 lbf} and counting the number of notches (clicking sound).






- If not within the specification, adjust the parking brake lever.

Parking brake lever stroke when pulled at 98 N {10 kgf, 22 lbf}
- 3-7 notches