LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2008 >> 6 V6-3.0L >> Repair and Diagnosis >> Steering and Suspension >> Wheels and Tires >> Wheel Stud / Lug Nut >> Service and Repair >> Front Axle

Front Axle

WHEEL HUB BOLT REPLACEMENT





1. Remove the hub bolt using the SSTs.

Note:
^ If the dust cover interferes with the wheel hub bolt and the wheel hub bolt cannot be removed, tap the part shown in the figure with a chisel lightly and bend the processing point back to the steering knuckle side.

2. Install the hub bolt into the wheel hub and install a washer and hub nut on the hub bolt.





3. Tighten the hub nut while holding the wheel hub using a brass bar.
scientia non olet · About LEMON Manuals