Evaporative Emission Control Canister: Testing and Inspection

CHARCOAL CANISTER INSPECTION

1. Remove the charcoal canister.




California emission regulation applicable ATX model




Except for California emission regulation applicable ATX model

2. Plug ports A and C, then blow air into port B.

CAUTION: Do not apply the pressure more than 20 kPa {0.2 kgf/sq.cm, 2.8 psi} to the charcoal canister. Doing so will damage the charcoal canister.

3. Verify that there is no air leakage from the case.
- If not as specified, replace the charcoal canister.