Side Air Bag Sensor No.2
SIDE AIR BAG SENSOR NO.2 REMOVAL/INSTALLATIONWARNING: Handling the side air bag sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the side air bag sensor.
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the following parts.
1. Trunk box
2. Seat side box
3. Trunk end trim
4. Third-row seat
5. Third-row seat belt lower anchor installation bolt
6. Trunk side trim
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to the ON position and hold for 10 s or more.
7. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
- If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the system. (See FLOWCHART.) Flowchart