Drive Belt Tensioner: Testing and Inspection

DRIVE BELT AUTO TENSIONER INSPECTION [MZI-3.5]
1. Remove the engine cover.
2. Remove the front wheel and tire (RH).
3. Remove the splash shield (RH).
4. Remove the generator and A/C drive belt.





5. Verify that the drive belt auto tensioner moves smoothly in the operational direction.
^ Replace the drive belt auto tensioner if necessary.

Tightening torque 8.9-12.1 Nm (91-123 kgf-cm, 79-107 in-lbf)





6. Turn the drive belt auto tensioner pulley by hand and verify that it rotates smoothly.
^ Replace the drive belt auto tensioner if necessary.

Tightening torque 8.9-12.1 Nm (91-123 kgf-cm, 79-107 in-lbf)

7. Install in the reverse order of removal.