Intermediate Shaft Speed (ISS) Sensor Removal / Installation

WARNING: This page is about a different variant/trim than selected.

With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
Disconnect intermediate shaft speed (ISS) sensor electrical connector.

Fig 1: Locating Intermediate Shaft Speed (ISS) Sensor Electrical Connector
Courtesy of MAZDA MOTORS CORP.
Remove ISS sensor.
1. Remove the screw.
2. Remove the ISS sensor from the transmission.
3. Inspect the ISS sensor O-ring for damage. If damaged, install a new O-ring.
Fig 2: Identifying ISS Sensor With Screw
Courtesy of MAZDA MOTORS CORP.
Inspect and lubricate O-ring with petroleum jelly.
1. Install the ISS sensor into the transmission.
2. Tighten the ISS sensor screw.
Fig 3: ISS Sensor With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
Connect OSS sensor electrical connector.

Fig 4: Locating OSS Sensor Electrical Connector
Courtesy of MAZDA MOTORS CORP.
Lower the vehicle.