Installation Note

WARNING: This page is about a different variant/trim than selected.

Install the digital TR sensor.
1. Position the digital TR sensor.
2. Loosely install the bolts.
Fig 1: Identifying Digital TR Sensor With Bolts
Courtesy of MAZDA MOTORS CORP.
NOTE:
- The manual lever must be in neutral.
Adjust the digital TR sensor.
1. Install the digital TR sensor alignment tool SST into the three slots on the digital TR sensor.
2. Tighten the bolts.
Fig 2: TR Sensor Alignment Tool SST Bolts With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Install the manual control outer lever.
1. Install the manual control outer lever.
2. Install the manual control outer lever nut.
Fig 3: Manual Control Outer Lever Nut With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
Connect the digital TR sensor electrical connector.

Fig 4: Locating Digital TR Sensor Electrical Connector
Courtesy of MAZDA MOTORS CORP.
Connect the selector lever cable to the manual control lever.

Fig 5: Connecting Selector Lever Cable To Manual Control Lever
Courtesy of MAZDA MOTORS CORP.
Adjust the selector lever cable. See SHIFT CABLE AND BRACKET ADJUSTMENT .
Lower the vehicle.
NOTE:
- When the battery has been disconnected and reconnected, some abnormal drive symptoms can occur while the vehicle re-learns its adaptive strategy. The customer needs to be notified that they may experience slightly different upshifts either soft or firm and this is a temporary condition and will eventually return to normal operating condition.
Connect the negative battery cable.