LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission [Service, Removal & Installation 5R44E/5R55E]) >> Automatic Transmission Insulator And Retainer Removal / Installation >> Installation Note

Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Install the transmission mount.
    1. Position the transmission mount on the extension housing.
    2. Install the transmission mount-to-extension housing bolts.
    Fig 1: Transmission Mount-To-Extension Housing Bolts With Torque Specification
    G04930511Courtesy of MAZDA MOTORS CORP.
  2. Install the transmission mount into the crossmember and tighten the transmission mount nuts.
    Fig 2: Transmission Mount Nuts With Torque Specifications
    G04930512Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Align the propeller shaft with the marks made during removal to ensure correct balance.
  3. Align and install the rear propeller shaft. See PROPELLER SHAFT REAR (4X2) REMOVAL / INSTALLATION or PROPELLER SHAFT REAR (4WD) REMOVAL / INSTALLATION .
    Fig 3: Locating Alignment Mark
    G04930513Courtesy of MAZDA MOTORS CORP.
  4. Install the rear propeller shaft bolts.
    Fig 4: Locating Rear Propeller Shaft Bolts With Torque Specifications
    G04930514Courtesy of MAZDA MOTORS CORP.
  5. Lower the vehicle.
  6. Fill the transmission to proper fluid level. Check for proper transmission operation.
scientia non olet · About LEMON Manuals