LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission [Service, Removal & Installation 5R44E/5R55E]) >> Automatic Transmission Extension Housing Seal And Bushing Removal / Installation - 4X2 >> Removal Note

Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Remove rear propeller shaft. See PROPELLER SHAFT REAR (4X2) REMOVAL / INSTALLATION .
    CAUTION:
    • Use the extension housing bushing remover carefully so that the seal area is not damaged.
  2. Using the slide hammer SST  and the torque converter fluid seal remover SST  , remove the extension housing seal.
    Fig 1: Identifying Slide Hammer And Torque Converter Fluid Seal Remover SST
    G04930489Courtesy of MAZDA MOTORS CORP.
  3. Install extension housing bushing remover SST  and remove extension housing bushing.
Fig 2: Identifying Extension Housing Bushing Remover SST
G04930490Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals