Installation Note

WARNING: This page is about a different variant/trim than selected.

Position the extension housing bushing into the extension housing.
CAUTION:
- The lube hole in the extension housing bushing must be aligned with the lube groove in the extension housing. This groove is located at the 3 o'clock position when viewed from the rear.
NOTE:
- Inspect the counterbore of the extension housing for burrs. Remove any burrs from the extension housing counterbore with an oil stone.
Fig 1: Locating Counterbore Of Extension Housing
Courtesy of MAZDA MOTORS CORP.
Use the transmission extension housing bushing installer SST to install the extension housing bushing.
CAUTION:
- The tool will bottom when bushing is in the proper position.
Fig 2: Identifying Transmission Extension Housing Bushing Installer SST
Courtesy of MAZDA MOTORS CORP.
Position new extension housing seal with drain hole in the 6 o'clock position.

Fig 3: Locating Drain Hole
Courtesy of MAZDA MOTORS CORP.
Use transmission extension housing fluid seal installer SST to install the extension housing seal.

Fig 4: Identifying Extension Housing Fluid Seal Installer SST
Courtesy of MAZDA MOTORS CORP.
NOTE:
- Inspect the propeller shaft slip-yoke for wear and damage. Replace if required.
Install rear propeller shaft. See PROPELLER SHAFT REAR (4X2) REMOVAL / INSTALLATION .
Fill the transmission to the proper fluid level. See AUTOMATIC TRANSMISSION PRELIMINARY INSPECTION , .
Check for proper transmission operation.