Automatic Transmission Extension Housing And Gasket Removal / Installation: Installation

Fig 1: Locating Parking Pawl

Courtesy of MAZDA MOTORS CORP.

1. Clean the extension housing and install new extension housing gasket. Make sure that the parking pawl, spring and shaft are correctly installed.
   Fig 2: Extension Housing Screws And Studs With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
   CAUTION:

   • Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
2. Install the extension housing.
   1. Position the extension housing.
   2. Install the extension housing screws.
   3. Install the extension housing studs.
   Fig 3: Transmission Mount-To-Extension Housing Screws With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
3. Install the transmission mount.
   1. Position the transmission mount on the extension housing.
   2. Install the transmission mount-to-extension housing screws.
   Fig 4: Transmission Mount Nuts With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
4. Install the transmission mount into the crossmember and tighten the transmission mount nuts.
   Fig 5: Locating Mark On Rear Driveshaft Yoke & Axle Flange

   Courtesy of MAZDA MOTORS CORP.
   NOTE:

   • Align the driveshaft with the marks made during removal to make sure of correct balance.
5. Align and install the rear driveshaft.
   Fig 6: Rear Driveshaft Bolts With Torque Specifications

   Courtesy of MAZDA MOTORS CORP.
6. Install the bolts.
7. Fill the transmission with clean automatic transmission fluid to the correct level and check for correct transmission operation. See AUTOMATIC TRANSMISSION PRELIMINARY INSPECTION , .