LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission [Service, Removal & Installation 5R44E/5R55E]) >> Automatic Transmission Cooler Tubes Removal / Installation >> Installation

Automatic Transmission Cooler Tubes Removal / Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the transmission fluid cooler inlet and outlet tubes and bracket onto the engine.
    • Tighten to 20 Nm {2.0 kgf-m, 15 lb-ft}.
  2. Connect the transmission fluid cooler inlet and outlet tubes to the transmission.
    • Tighten to 28 Nm {2.9 kgf-m, 21 lb-ft}.
  3. Connect the transmission fluid cooler inlet and outlet tubes to the radiator.
scientia non olet · About LEMON Manuals