LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission [Service, Removal & Installation 5R44E/5R55E]) >> Automatic Transmission Cooler Tubes 3.0L/4.0L Removal / Installation >> Removal

Automatic Transmission Cooler Tubes 3.0L/4.0L Removal / Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist.
  2. Disconnect the transmission fluid cooler lower inlet and outlet tubes from the radiator.
  3. Disconnect the auxiliary transmission fluid cooler hoses from the transmission fluid cooler inlet and lower inlet tubes, and remove the lower inlet tube.
  4. Disconnect the transmission fluid cooler inlet and outlet tubes from the transmission.
  5. Remove the transmission fluid cooler tube bracket and the transmission fluid cooler inlet and outlet tubes from the engine.
scientia non olet · About LEMON Manuals