LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 561 (Lubrication) >> Oil Filter Replacement - 3.0L

Oil Filter Replacement - 3.0L

WARNING: This page is about a different car, the 2007 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil filter.
  2. Clean the cylinder block mating surface.
  3. Apply a small amount of clean engine oil to the oil gasket of the new filter.
  4. Install the oil filter and tighten it by hand until the oil gasket contacts the mounting base.
  5. Tighten the filter 1/2 turn.
  6. Start the engine and check for leaks.
  7. Check oil level and add if necessary.
scientia non olet · About LEMON Manuals