LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 560 (Exhaust System) >> Muffler And Tailpipe Removal / Installation - 3.0L/4.0L >> Removal Note

Removal Note

WARNING: This page is about a different car, the 2007 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not use oil or grease-based lubricants on the isolators. These lubricants may cause deterioration of the rubber. This can lead to separation of the isolator from the exhaust hanger bracket during vehicle operation.
  1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
  2. Remove the exhaust Y-pipe assembly-to-muffler and tailpipe assembly bolts, flag nuts and gasket.
  3. Disconnect the 3 rubber isolators and remove the muffler and tailpipe assembly.
scientia non olet · About LEMON Manuals