Engine Air Cleaner Removal / Installation - 3.0L

WARNING: This page is about a different car, the 2007 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.

Loosen the clamp and disconnect the engine air cleaner (ACL) outlet pipe from the air cleaner outlet
Tightening torque:

3 Nm {0.3 kgf-m, 27 in-lbf}
Disconnect the MAF sensor electrical connector.
NOTE:
- Pry the engine air cleaner from the base.
Remove the ACL assembly.

Fig 1: Removing ACL Assembly
Courtesy of MAZDA MOTORS CORP.
NOTE:
- Clean the engine air cleaner with a dry, clean cloth.
To install, reverse the removal procedure.