Accelerator Cable Removal / Installation - 3.0L

WARNING: This page is about a different car, the 2007 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.

Remove the air cleaner outlet tube.

Fig 1: Locating Air Cleaner Outlet Tube Hose Clamp
Courtesy of MAZDA MOTORS CORP.
Remove the screws and remove the accelerator control splash shield.

Fig 2: Locating Accelerator Control Splash Shield Mounting Screws
Courtesy of MAZDA MOTORS CORP.
Remove the return spring. Disconnect the accelerator cable from the throttle lever and the bracket.

Fig 3: Locating Accelerator Cable Bolt
Courtesy of MAZDA MOTORS CORP.
Disconnect the accelerator cable from the accelerator pedal and shaft.

Fig 4: Disconnecting Accelerator Cable
Courtesy of MAZDA MOTORS CORP.
Press the clips and remove the accelerator cable from the accelerator pedal and shaft.

Fig 5: Locating Accelerator Cable
Courtesy of MAZDA MOTORS CORP.
To install, reverse the removal procedure.