Engine Mount RH Removal / Installation - 3.0L: Installation

All vehicles 

1. Position the engine support insulator.

   4WD vehicles 

   Fig 1: Locating Engine Support Insulator Nut (4WD Vehicles)

   Courtesy of MAZDA MOTORS CORP.
2. Install the engine support insulator nut.

   Tightening Torque 103 Nm {10.5 kgf-m, 76 ft-lbf} 

3. Install the RH front halfshaft.

   2WD vehicles 

   Fig 2: Locating Engine Support Insulator Nut (2WD Vehicles)

   Courtesy of MAZDA MOTORS CORP.
4. Install the engine support insulator nut.

   Tightening Torque 103 Nm {10.5 kgf-m, 76 ft-lbf} 

5. Install the right front spring. See SPRING .

   All vehicles 

6. Lower the engine and remove the three-bar engine support SST  .
   Fig 3: Locating Engine Support Insulator Nuts

   Courtesy of MAZDA MOTORS CORP.
7. Install the engine support insulator nuts.

   Tightening Torque 109 Nm {11.1 kgf-m, 80 ft-lbf} 

8. Remove the lifting eyes SST  .
9. Install the fan blade. See COOLING FAN AND CLUTCH REMOVAL / INSTALLATION -- 3.0L .
10. Install the hood.
11. Connect the battery.