LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 558 (Engine Mechanical [Service Information 3.0L]) >> Crankshaft Rear Oil Seal Removal / Installation - 3.0L >> Removal Note

Removal Note

WARNING: This page is about a different car, the 2007 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the flywheel or flexplate. See FLYWHEEL REMOVAL / INSTALLATION - 3.0L , .
    CAUTION:
    • Use care to avoid scratching or damaging the oil seal surface or leakage may occur.
  2. Using a sharp awl, punch one hole into the crankshaft rear oil seal metal surface between the seal lip and the cylinder block.
  3. Screw the threaded end of the jet plug remover SST  into the oil seal and remove the crankshaft rear oil seal.
Fig 1: Identifying Jet Plug Remover SST
G04929471Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals