Air Cleaner Element Removal / Installation - 2.3L

WARNING: This page is about a different car, the 2007 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

Remove the tube from the mass air flow (MAF) sensor.
Tightening torque: 3 Nm {0.3 kgf-m, 27 in-lbf}

Fig 1: Disengaging Engine Air Cleaner Snap Clamps
Courtesy of MAZDA MOTORS CORP.
Disengage the two engine air cleaner snap clamps.

Fig 2: Lifting Engine Air Cleaner Cover
Courtesy of MAZDA MOTORS CORP.
Lift the engine air cleaner cover.

Fig 3: Removing Air Cleaner Element
Courtesy of MAZDA MOTORS CORP.
Remove the air cleaner element.
CAUTION:
- Snap clamps must be engaged or damage to the engine may occur.
To install, reverse the removal procedure.