Installation Note
WARNING: This page is about a different car, the 2007 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
- Install new valve cover gaskets.
- Position the valve cover and install the bolts in the sequence shown.
- Tightening torque:
- 10 Nm {1.0 kgf-m, 89 in-lbf}
- Connect the crankcase ventilation tube quick connect coupling.NOTE:
- Apply clean engine oil to the O-ring seal prior to installation.
- Install the CMP sensor and the bolt.
- Tightening torque:
- 7 Nm {0.7 kgf-m, 62 in-lbf}
- Connect the CMP sensor electrical connector.
- Position the ignition coil and install the 4 bolts.
- Tightening torque:
- 6 Nm {0.6 kgf-m, 53 in-lbf}
- Connect the ignition coil electrical connector.
- Connect the spark plug wires to the spark plugs.
- Install the engine wiring harness support bracket retainers onto the valve cover studs.
- Connect the CHT sensor electrical connector.
- Position back the CHT sensor boot.
- Install the intake manifold. See INTAKE MANIFOLD REMOVAL / INSTALLATION - 2.3L , .
- Connect the negative battery cable. See BATTERY DISCONNECT .