LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Engine Mechanical 2.3L Service Information) >> Crankshaft Rear Oil Seal Removal / Installation - 2.3L >> Installation

Crankshaft Rear Oil Seal Removal / Installation - 2.3L: Installation

WARNING: This page is about a different car, the 2007 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Tightening Sequence Of Crankshaft Rear Oil Seal Bolt
G04929150Courtesy of MAZDA MOTORS CORP.
  1. Install the crankshaft rear oil seal on the crankshaft.
    • Tighten the bolts in the sequence shown to 10 N.m {1 kgf.m, 7 lbf}.
  2. Install the oil pan. See, OIL PAN REMOVAL / INSTALLATION -- 2.3L .
  3. Install the flywheel or flexplate. See FLY-WHEEL/FLEXPLATE REMOVAL / INSTALLATION - 2.3L , .
scientia non olet · About LEMON Manuals