LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 552 (Cooling System) >> Engine Coolant Replacement - 2.3L >> Filling and Bleeding Procedure For Use With Partial Drain

Filling and Bleeding Procedure For Use With Partial Drain

WARNING: This page is about a different car, the 2007 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the radiator draincock is completely closed.
  2. Fill the system through the degas bottle cap to 15 mm above the maximum fill level.
  3. Install the degas bottle cap.
    WARNING:
    • Do not stand in line with or near the engine cooling fan blade when revving the engine. Failure to follow these instructions may result in personal injury.
  4. Start the engine and hold the engine speed at 2,500 RPM for approximately eight minutes until the thermostat opens.
  5. Maintain the engine speed at 2,500 RPM for an additional three minutes.
  6. Increase engine speed to 4,000 RPM and hold for five seconds.
  7. Return the engine speed to 2,500 RPM and hold for an additional three minutes.
  8. Stop the engine and check for leaks.
scientia non olet · About LEMON Manuals