LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Mechanical) >> Removal & Installation >> Oil Pan >> Removal

Oil Pan: Removal

WARNING: This page is about a different car, the 2002 Mazda B3000 and 2001 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: To remove oil pan on 4WD models, engine must be removed. See ENGINE .
  1. Disconnect negative battery cable. Reference mark hood location and remove hood. Remove dipstick. Remove cooling fan assembly.
  2. Remove motor mount nuts. Install Engine Lifting Hooks (303-D030). Using a floor jack, raise engine about 2 inches. Install Engine Support Kit (014-00750) to engine. Raise vehicle on hoist. Remove retainer clip and electrical connector at oil low level sensor. Drain engine oil.
  3. Remove starter. Remove oil pan bolts. Carefully remove oil pan. DO NOT damage oil pump pick-up tube. Remove oil pan gasket.
scientia non olet · About LEMON Manuals