LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Mechanical) >> Removal & Installation >> Camshaft Bearings >> Installation

Camshaft Bearings: Installation

WARNING: This page is about a different car, the 2002 Mazda B3000 and 2001 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align oil hole in bearing with oil hole in bearing bore. Using camshaft bearing remover/installer, install new camshaft bearings. Ensure front bearing is installed .020-.035" (.51-.89 mm) below front face of cylinder block.
  2. Coat sealing edge of NEW rear camshaft bearing bore plug with oil resistant sealer, and install bore plug. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals