Belt TENSIONER Removal / Installation - 4.0L

1. Remove the drive belt. See DRIVE BELT REMOVAL / INSTALLATION - 4.0L , .
2. Remove the belt tensioner bolt and the belt tensioner.
3. To install, reverse the removal procedure.
   NOTE:

   • Observe the location of the alignment tab on installation.
   Fig 1: Locating Alignment Tab

   Courtesy of MAZDA MOTORS CORP.

Fig 2: Locating Alignment Tab

Courtesy of MAZDA MOTORS CORP.

Tightening Torque 

47 Nm {4.8 kgf-m, 35 ft-lbf}