LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B3000 V6-3.0L >> Repair and Diagnosis >> Transmission and Drivetrain >> Drive Axles, Bearings and Joints >> Axle Shaft Assembly >> Axle Shaft >> Testing and Inspection >> Axle Shaft Pilot Runout Rear

Axle Shaft Pilot Runout Rear

AXLE SHAFT PILOT RUNOUT REAR
1. Position the Dial Indicator with Bracketry with Clutch Housing Alignment Adapter SST 308-021 (T75L4201-A) to the pilot, as close to the hub or axle flange face as possible. Zero the indicator to allow the pointer to deflect either way.





2. Rotate the hub or flange one full turn and note the maximum and minimum readings. The difference between the maximum and minimum readings will be the total pilot runout. Pilot runout must not exceed 0.15 mm (0.006 inch).
scientia non olet · About LEMON Manuals