LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B3000 V6-3.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Drive Belt Tensioner >> Service and Repair

Drive Belt Tensioner: Service and Repair

BELT TENSIONER REMOVAL / INSTALLATION - 3.0L
1. Remove the drive belt.
2. Remove the belt tensioner bolt and belt tensioner.
3. Install in reverse order of removal.





4. Observe the location of the alignment tab on installation.





5. Position the belt tensioner and install the bolt.
Tightening torque: Tighten to: 24 - 31 Nm 2.4 - 3.2 kgf-m, 18 - 23 ft. lbs. ).
scientia non olet · About LEMON Manuals