LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B2300 Standard >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Propeller Shaft >> Propeller Shaft Rear (4WD) Removal / Installation

Propeller Shaft Rear (4WD) Removal / Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
  2. Index-mark the propeller shaft yoke to transfer case companion flange.
    Fig 1: Indexing Companion Flange
    G04308974Courtesy of MAZDA MOTORS CORP.
  3. Index-mark the propeller shaft to rear companion flange.
    Fig 2: Indexing Companion Flange
    G04308975Courtesy of MAZDA MOTORS CORP.
  4. Remove the four rear bolts and disconnect the rear propeller shaft.
    Fig 3: Bolts With Torque Specifications
    G04308976Courtesy of MAZDA MOTORS CORP.
  5. Separate the propeller shaft from the transfer case.
    1. Remove the four bolts.
    2. Carefully remove the propeller shaft.
    NOTE:
    • Install new bolts.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals