Inspection and Verification

Visually inspect the following for obvious signs of mechanical or electrical damage.

Visual Inspection Chart

VISUAL INSPECTION CHART

Mechanical	Electrical
Binding linkage or latches Door tack cylinder Misaligned door	Fuse(s) Circuitry Remote keyless entry (RKE) transmitter Door lock control switch Door lock actuator SJB

If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
NOTE:
- Make sure to use the latest scan tool software release.
If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
NOTE:
- The vehicle communication module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.
- If the scan tool does not communicate with the VCM:
- Check the VCM connection to the vehicle.
- Check the scan tool connection to the VCM.
- See COMMUNICATIONS NETWORK , .
If the scan tool does not communicate with the vehicle:
- Verify the ignition key is in the ON position.
- Verify the scan tool operation with a known good vehicle.
- See COMMUNICATIONS NETWORK , .
Carry out the network test:
- If the scan tool responds with no communication for one or more modules, See COMMUNICATIONS NETWORK , .
- If the network test passes, retrieve and record the continuous memory DTCs.
Clear the continuous DTCs and carry out the self-test diagnostics for the SJB.
If the DTCs retrieved are related to the concern, See SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX , .
If no DTCs related to the concern are retrieved, See SYMPTOM TROUBLESHOOTING CHART - SECURITY AND LOCKS , .