Sunroof / Moonroof Motor: Service and Repair
SUNROOF MOTOR REMOVAL/INSTALLATION1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the following parts:
1. A-pillar trim
2. Front scuff plate inner
3. Rear scuff plate
4. B-pillar lower trim
5. Front seat belt upper anchor installation bolt
6. B-pillar upper trim
7. Rear package tray lid
8. Sub-trunk
9. Third-row seat
10. Trunk end trim
11. Rear header trim
12. Third-row seat belt lower anchor installation bolt
13. Cargo compartment light
14. Trunk side trim
15. Second-row seat belt upper anchor installation bolt
16. C-pillar trim
17. Map light
18. Sunvisor
19. Assist handle
20. Headliner
4. Disconnect the sunroof motor connector.
5. Remove the screws, then remove the sunroof motor.
6. Install in the reverse order of removal.
NOTE: If the glass panel or the sunroof motor is moved with the sunroof motor removed, initial position setting of the sunroof motor will be required. Perform initial position setting referring to the Sunroof Motor Assembly Note.